Tiny raw materials can easily stick in the tire shredder

  During the work of the shredder, the material composition, small breaks are easily stuck inside, which increases the difficulty of crushing, so the more fine crushes, the greater the impact on shredder crushing.

This means that the finer the material contained in the material before the crushing, the easier it is for the small raw materials to stick to the shredder cavity. In the case that the material contains too many small damages, the tire shredder must also be screened before crushing; tire recycling machine wear-resistant crushing parts (hammer, jaw) of the crushing equipment (hammer, jaw) The better the sex, the greater the crushing ability of the tire shredder, and vice versa.

  Regarding the detection of the reversal of the tire recycling machine before use: When the power is turned on, use the idle operation in advance to check whether the steering is normal.

If it is abnormal, there is a problem with the positive and negative poles of the power supply. Check the power connection in time to ensure normal steering; secondly, when the tire recycling machine is changing tools, the blade should extend between two and four centimeters, because if there is too much, it will touch the surrounding of the device, which will eventually lead to The tool is damaged.

Tighten the bolts as well. There should be no signs of looseness. Once the bolts become loose during use, the danger of the tool itself will greatly increase.