Causes and solutions of equipment hammer overheating

During the use of the tire shredder hammer, we often encounter some phenomena. Among them, the problem of overheating of the hammer head is common, which affects the service life and working efficiency of the tire shredder hammer, and the cause of the overheating of the wear hammer is still There are many kinds, so if you want to solve this problem, you must find out that the hammer head is overheating for that reason. Let's take a look at the causes of the overheating of the wear-resistant hammer head and the corresponding solutions:

    1. If the tapping sound appears in the elastic coupling, it can be basically determined that the pin is loose and the elastic ring is worn. The corresponding solution is to stop and tighten the shaft nut and replace the elastic ring.

    2. If the tire shredder bearing is overheating, then it can be determined that the grease is insufficient or excessive, or the grease is dirty and deteriorated, and the bearing is damaged. The corresponding solution is to add an appropriate amount of grease, and the grease in the bearing should be 50% of its space volume. Clean bearings and replace grease and bearings.

    3. If the output of the tire recycling machine is reduced, it may be because the gap of the screen bar is blocked or the feeding is not uniform. The solution is to stop the car, clean up the blockage in the gap of the screen bar, or adjust the feeding structure.

    4. If there is a knocking sound inside the tire recycling machine, it is because non-broken objects enter the inside of the machine; the lining board fasteners are loose, and the hammer hits the lining board; the hammer or other parts are broken; the corresponding solution: stop the car, Clean the crushing cavity; check the fastening of the liner and the gap between the hammer and the screen; replace the broken parts.

5. If the discharge granularity of the tire recycling machine is too large, it may be caused by excessive wear of the wear-resistant hammer head or the screen bar is broken. The corresponding solution is to replace the hammer head or screen bar.