What are some tips for tire shredder maintenance?

There are some tips for tire shredder maintenance. These tips will help everyone to do a better and more comprehensive maintenance of the equipment:

After the tire shredder motor works for a certain period of time, it is necessary to refuel or open and clean the bearings, and refill the lithium-based lubricant. Restores the lubricity of the bearing.

Tire recycling machine Adjusting the tension of the V-belt When the V-belt is too tight, the motor bearings will heat up and the speed will decrease when it is too loose. The V-belt will also slide easily, which affects the service life. When adjusting the tension of the V-belt, you can loosen the bolts that fix the motor base, and use the adjusting bolt to change the position of the motor on the slideway to make the V-belt to the required tightness, and then tighten the fixing bolts.

If the tools of the tire recycling machine are not good enough, it will easily lead to the situation of broken tools and scraps. This situation is generally caused by the inconsistency between the rotation center of the spindle of the tire recycling machine and the center of the tool during processing. When the spindle is running at high speed, if the spindle and the tool are not concentric, it will not only affect the rubber molding degree and product yield, but also affect the processing effect.

The power cord of the tire recycling machine motor should not be too long or twisted. This can easily cause the motor to undervoltage or undercurrent. I know that the working voltage of the motor is 380 volts, and the working current is marked on the motor nameplate. The rated current of the wire must be greater than the rated current of the motor. Otherwise, the motor will be easily heated or burned under the condition of under voltage or under current.