How to solve the problem of waste metal shredder blocking material (1)

After rapid development in recent years, the steel industry has gradually shown contradictions such as insufficient natural resources, excessive energy consumption per ton of output, and environmental pollution. As the “second mining industry” of steel industry, scrap steel resources have the advantages of saving energy, reducing pollution, protecting the environment, recycling and so on.

Recycling of scrap metal requires the use of scrap metal crusher equipment. After years of practical experience and market research, it is understood that in order to prevent the material from clogging and stable operation, waste metal shredder must be debugged and installed according to technical requirements, creating good conditions for the stall metal shredder blocking material. How to solve the phenomenon.

1. The scrap metal crusher discharge pipe is not smooth or the plugging feed is too fast, which will block the pulverizer air outlet; improper matching with the conveying equipment will cause the discharge pipe wind to weaken or block after the wind. After the fault is detected, the conveying equipment whose delivery port is not matched shall be cleared first, and the feeding amount shall be adjusted to make the equipment operate normally.