The important role of the screen of the scrap metal shredder

If the gap is exceeded in a particular production and the diameter of the bottom hole is large, it will have an adverse effect on production.

When the material is required to be rough, if the diameter of the bottom hole meets the production requirements of the scrap metal crusher, but the gap between the blade and the bottom of the screen is too small, it is easy to cause the material to get stuck on the screen, resulting in damage to the bottom of the screen;

When the gap between the blade and the bottom of the screen is too large, if the diameter of the bottom hole is too small, the waste metal shredder feed will be stuck, and even if it is serious, the motor will burn out, causing the production to stagnate.

When scrap metal needs fine pulverization production, if the bottom hole diameter of the scrap metal shredder meets the requirements, but the gap between the insert and the bottom of the screen is large, it will also cause difficulty in feeding, and even burn the motor.

When the diameter of the bottom of the screen is too large and the gap between the hammer and the bottom of the screen is too small, the scrap metal crusher does not meet the production design requirements, and the finished product size does not meet the production requirements, resulting in waste of equipment and materials.

Therefore, in the actual operation of production, the internal structure of the scrap metal crusher should be properly adjusted according to the production needs to ensure that the equipment is in a good operating environment and maintain efficient production capacity.