How to maintain the tire reducer in daily use?

As an important part of the tire shredder, the reducer should be repaired and maintained in daily production.

Maintenance of the tire shredder reducer

1. Lubricating oil, the lubricating oil used in the reducer adopts the extreme pressure gear N220 or N320 in GB/T5903-1986, N220 when the ambient temperature is less than 30 °C, and N320 when the ambient temperature is higher than 30 °C. .

2. The cooling system of the reducer adopts the normally open mode, and the lubrication method is lubricated by the oil immersion cycle. Before the roller press system is started, the lubrication system must be started to confirm that the lubrication points are supplied with oil for 3-5 minutes before the speed reducer can be rotated. The installed reducer needs to drive the reducer input shaft at low speed after refueling to the middle line of the oil mark to ensure oil lubrication of each bearing in the reducer.

3. After the initial operation of the reducer for 300 hours, the oil should be replaced once. Before the oil change, the oil in the tank is cleaned with oil with low viscosity. After every 12 months, the oil is changed. For the continuous operation in the day and night, the oil is changed every 6 months. Rinse the reducer with light oil before the new oil is installed.

 

Yuxi Machinery tire shredder, using cutting tool for shearing, tearing, squeezing working principle process the material, crushing different solid waste, and good effect for hard and soft materials.

This tyre shredder adopts low speed, big torque design, has high shear force, good effect shredding effect, low noise, stable, etc feature.

Yuxi Machinery also produces the entire production line for tire recycling machine, namely the tire recycling plant.