Selection and use of tire shredder tools

The quality of the tire recycling machine knives is determined by his blades. The quality of the blade is determined by its material, which material is used to make the wood tire recycling machine blade is based on the material needed to shred the product.

The blade has three types of ordinary processing, multi-knife structure and spiral surface structure. These three feeding methods have oblique feeding and flat feeding. Long logs are usually fed with flat mouth, while short logs and slabs are generally fed with diagonal mouth.

When we are feeding to the feeding port, we need to check whether the scrap material required is scrap metal or other hard materials. If there is, it should be cleaned to avoid chipping of the tire shredder blade when it is shredded, and check whether there is a blade that is about to fall off in the wood tire shredder blade group before work every day. . Because the blades are damaged, you don't know when they will fall off. If they fall off in the material box, it will cause a group of blades to be reimbursed. In severe cases, it will also cause operator casualties.

Before starting, check whether the rotor of the blade is flexible and reliable, and then turn the wheel by hand. Is the rotation direction of the wheel the same as the direction indicated by the arrow of the machine? Is there any collision in the crushing room?

Whether the blade is well lubricated. During work, pay attention to the operation of the tire recycling machine blade at any time. If noise, vibration, high temperature of the bearing and the body are found, and outward spraying, etc., you must stop the inspection in time. After starting the tire recycling machine, let it idle for two minutes to ensure that the motor starts normally. During the feeding process, it is necessary to keep as uniform as possible to avoid overloading the equipment caused by centralized feeding.