More output is not necessarily a good thing for shredder

The tire recycling machine is to break large tires into small ones. Generally speaking, there should be a certain range of control over the size of the material. If the material is too large, it is necessary to check and adjust it .

The gap between the impact plate of the tire recycling machine and the hammer head is too large, the impact density of the plate hammer on the material is low, and the granularity of the impact received by the material is not enough. The hammer can't break the material very well. Of course, the tire will have too coarse particle size, and the reason for the large particle size of the material will appear:

(1) The gap between the hammer and the strike plate is too large;

(2) The hammer is worn;

(3) The rotor speed is too low. Generally, the gap between the impact plate and the hammer is 15-20mm.

Of course, the size of the feed and the size of the block will also have a certain effect on the size of the output. When the size of the feed is large and the feed flow is large, the crushing cavity of the impact tire shredder will become full. In order to avoid the blocking phenomenon that increases the load of the equipment, the material is discharged from the discharge port before the material is sufficiently broken in the crushing cavity; the hardness of the crushed material will also affect the crushing size of the tire shredder. The bigger the work efficiency is, the more reasonable the particle size of the material can be adjusted according to the actual needs.

Therefore, don't panic if this kind of problem arises. This will not solve the problem. What we need is to take out our own professional knowledge to solve it. This is a better way to better solve the problem of tire recycling machine.