Maintenance precautions for tire shredder(1)

In general, metal things are more difficult to break and shred, so it is also difficult to work with the tire recycling machine, and failures are common, but

The most important thing is how to repair. The large shredder below lists a few common faults and solutions for tire recycling machines. Here are some tips for maintenance.

1.If the rivet head of the impeller is severely worn, the impeller body and the hub are compacted by electric welding to restore the damaged rivet head to its original normal state.

2.The tire recycling machine is easy to produce fatigue cracks in the rivet holes. You can use unused electrodes to repair the cracks. The remaining electrodes after welding and the symmetrical electrodes are repaired. Ensure that the weight of the welding patch is equal. If there is no crack in the symmetrical rivet hole, the electrode should also be deposited here to offset the newly added welding weight of the crack in the symmetrical rivet hole. Welding according to this symmetrical weighting method can repair cracks.

3. The tire shredder performs a simple dynamic balance test on the impeller, and the method is very simple. Use an object to support the impeller, pull it by hand, and try to rotate it gently. The place that does not reach the balance will stop at the lowest point and swing left and right. If there is partial weight, you can spot weld the impeller on the opposite side to increase the weight to balance it, or use an angle grinder to remove the weld marks of the partial impeller, and balance can be achieved, so that the fan can be repaired for normal work.

4. The new tire recycling machine solves the shortcomings of the old tire recycling machine blades. It uses a specially designed spindle and cutter head. The cutter head is very durable. It does not need to be replaced. It only needs to make up the knife on the cutter head.

5.In order to be able to separate the iron and aluminum particles in the metal material, the new tire shredder is equipped with a conveying device.The conveying and magnetic separation are two in one.It is the output material after the crushed metal material can be separated from the metal. Aluminum and iron.