Some considerations for using tire shredder

Experienced masters can almost judge whether the tire shredder is in the normal state from the sound, temperature, and operation of the tire recycling machine. The following large tire recycling machine will introduce some precautions for the use of the tire shredder:

First. Inspection before trial run of biaxial tire shredder

1Multi-point dry oil pump and its oil supply situation.

2. Whether the adjustment position of the wedge-shaped adjustment block meets the design technical requirements.

3. Turn the car to see if there are any stuck areas, and drive after everything is normal.

4. Confirm the direction of rotation, how to test run the motor alone without load for 2 h, check the bearing temperature.

6. Turn the car to avoid the flywheel from dead point, so that it can overcome its inertia when starting.

7. Install the V-belt, adjust its tension and the parallelism between the two wheels.

8. Before starting the equipment, the dry oil pump must be started to refuel each lubrication point.

9.No-load trial operation is 4 hours, and the dual-axis tire recycling machine should meet the following requirements during operation:

Second. There should be no abnormal sound between the toggle and the bracket.

Third. There should be no loud noise between the locking spring and the drawbar.

Fourth, the temperature rise of the bearing should not be greater than 30 ° C. There must be no abnormal fluctuations.

Fifth, the cleaning of the reducer of the dual-shaft tire recycling machine should not use high-pressure water guns and other materials with excessive impact force to avoid damage.

Sixth .pairs of reducers should be added in time to protect.