Prevents tire shredder from overload during long working hours

Check the tire shredder equipment. If the shredder is driven by a diesel engine, the power of the two engines should match, that is, the power of the diesel engine is slightly greater than the power of the shredder, and the pulley grooves of the two engines do not match. The outer end of the pulley should be at On the same plane, before starting, please check whether the connecting bolts of all parts of the equipment are tightened, the belt is elastic, the power cord is normal, and the motor shaft is parallel to the shredder shaft? Check the blade to see if it works.

  Fix and install the tire recycling machine equipment. The fixing work of the tire tire recycling machine should be fixed on the cement foundation. If the working position needs to be changed frequently, the shredder and electrical equipment should be made of angle iron on the seat to avoid tire shredder. Damage caused by sports, safety production and operation requirements of tire shredder at work. In work, please always pay attention to the working state of the shredder, and feed it evenly to prevent blockage and overload during long-term work. If there is vibration, noise, high temperature and splashing between the bearing and the body, please Stop the inspection immediately. If there is no problem, please continue to work. You should carefully check whether there are damaged materials. Do not mix in foreign objects such as stones and metals to avoid damaging the machine.

  When the tire shredder is working, the operator must not disassemble the equipment or disassemble the machine, check the working status of the shredder room, and do not place maintenance tools on the machine or packaging. The operator should not wear gloves. Enter the hopper. When feeding, please stand beside the shredder to prevent the debris from rebounding and hurting the face. Do not stop immediately after the work. It should be left idle for 2-3 minutes to allow the material in the machine to be completely discharged. Note: After starting the machine, leave the device idle for 2-3 minutes to check whether the rotor is rotating correctly and the sound is normal. It only works when it is stable at the extra speed.

  Maintenance and protection of tire shredder equipment after shutdown. Cleaning and maintenance should be stopped after the tire tire recycling machine is stopped. Blades are the main consumable parts. After wear, the entire blade group should be replaced together, regardless of whether the blades are in the same direction or the same direction. When replacing, when replacing a new blade, the entire blade set should also be replaced, not the old blade with one blade. After 300 hours of operation, the tire tire recycling machine should clean the bearings and change the oil, and the belt should be removed when working for a long time.