Identify tire shredder failures and eliminate hidden dangers

  Tire shredder said that it is a two-shaft shredder in plain white, but according to the different raw materials and output requirements of the customer, the shredder cutters and power are replaced. The appearance is generally the same. Today, Yuxi Machinery has the causes of tire recycling machine failures and solutions Ways to do a detailed explanation for you to eliminate hidden dangers for you.

Tire recycling machine is prone to some minor faults when working, but there are many reasons. Let's analyze the causes of the faults:

1. Cantilevered parts. After disassembly, it was found that the sliding bearing of the suspension shaft was dead, and there was a large amount of sludge in the suspension shaft cavity. The reason is that the gap between the air outlets is large, and the air pressure in the cavity of the suspension shaft is smaller than that in the grinding cavity, so that dust enters the cavity of the suspension shaft.

2. Grinding cavity. After the machine is stopped, the grinding chamber is opened, and some rollers are found to rotate without turning when using a manual disk. The rollers and grinding rings have collapsed. It is caused by poor lubrication of the roller bearings. It should be processed strictly according to the technical requirements on the figure. After processing, non-destructive testing of each pin is required.

3. In order to ensure that the pins of the tire shredder are uniformly stressed, the pin holes of the motor pair wheel and the compressor flywheel need to be reprocessed.

4. Ensure the assembly accuracy of the coupling and the concentricity requirements of the motor and compressor, formulate a reasonable disassembly and assembly scheme, and use a torque wrench to evenly lock the pins when tightening.

5. After taking the above measures, the reformed C1101 compressor runs smoothly, the coupling pin does not break any more, and the hidden dangers of the tire recycling machine are completely eliminated.