Improve the efficiency of tire shredder

Clogging of tire recycling machine is one of the common faults in the use of tire shredder. There may be problems in the design of the machine and tools, but it is more caused by improper operation.

(1) the feeding speed is too fast, and the load increases, causing congestion. In the feeding process, always pay attention to the ammeter pointer deflection Angle is large, if the rated current exceeds, indicating that the motor overload, long time overload, will burn out the motor.

In this case, the material door should be immediately reduced or closed. The feeding mode can also be changed to control the feeding amount by increasing the feeder. There are two kinds of feeder: manual feeder and automatic feeder. The user should choose the appropriate feeder according to the actual situation.

Due to the high rotation speed and large load of tire recycling machine, and the strong fluctuation of load. Therefore, the current of the tire recycling machine is generally controlled at about 85% of the rated current.

(2) the outlet pipe is not free or blocked too fast, which will cause the outlet of the grinder to be blocked; Improper matching with the conveying equipment will lead to the material pipeline wind weakened or blocked after no wind. After finding out the fault, it is necessary to change the mismatched conveying equipment and adjust the feeding amount to make the equipment run normally.

(3) tire shredder will be blocked due to hammer fragments, aging, mesh closure, tattered, and high water content of crushed materials. Should update the broken and seriously aged hammer regularly, maintain the good working state of the crusher, and check the screen regularly, the moisture content of the crushed material should be less than 14%, which can not only improve the production efficiency, but also make the crusher not blocked, enhance the reliability of the crusher work.