What should pay attention to when opening shredder?

The large waste metal shredder is a new type of multi-functional twin-shaft shredder that not only recycles scrap metal, but also recycles used wood and plastic.

After purchasing the waste metal shredder, the user must follow the prescribed operating procedures. Only the correct and skilled use of the scrap metal crusher will not cause unnecessary damage.

The following is a description of the machine shop, scrap metal crusher notes and operating procedures.

The large scrap metal crusher starts the motor running at no load. If the technical conditions of each part are normal, the load can be operated normally.

There should be no magnetic or frictional sounds in the operation of metal shredder.

The screen should be securely installed, sealed, and watertight, and the screen frame should be tightened.

During the work of large metal shredder, if abnormal noise is found, the material is clogged, the bearing or motor overheats, stop feeding, stop inspection and troubleshooting.

At the end of the work, the machine will work for 2-3 minutes.

Once the material is completely removed, the shredder and fan can be stopped.

Safety production must be strictly guaranteed during operation.

It is strictly forbidden to increase the speed of the large metal shredder. Always check the opening pin on the pin. If there is excessive wear, replace it immediately.