Metal shredder for extending wear parts

In the process of using the waste metal shredder, after a long period of work wear, the scrap metal crusher machine causes wear or deformation of the parts due to factors such as beatings and impacts. This wear is unavoidable during long machine operations.

So how do you extend the replacement frequency of wear parts?

Regarding the waste metal shredder can use the auxiliary support method to deal with the rigidity of the thin change machine, it is feasible to use the shredder base frame or the tool holder to improve the bearing strength. Together, the touch stiffness of the shredder parts is improved good way.

 In most cases, the touch stiffness of scrap metal crusher components is much lower than the stiffness of the part itself, so progressive touch stiffness is the key to improving the stiffness of the process system.

Pay attention to investigating that the temperature of the rolling bearing of the shredder main shaft should not exceed 65 degrees. If the temperature is higher than this temperature, the oil should be replaced. If there is no improvement, the bearing should be completely cleaned and oiled.

The blade collapses or becomes dull, and the four knives are replaced or ground together to ensure that the cutter head is flat and the bottom blade is replaced in the same time.

In this way, it is possible to greatly reduce the damage of the chip machine parts and extend the replacement cycle.

At present, the products of Yuxi machinery involve single machine or supporting production lines in the fields of plastics, home appliances, metals, tires and wood such as tire shredder,scrap metal crusher,Radiator recycling machine&car shredder. This waste tire recycling machine is one of solid waste recycling.