Metal shredder bearing heat is caused by the following problems

In order to achieve “environmental protection” and “energy saving”, the waste metal shredder must ensure that the materials produced are of high cleanliness, large output, low noise, no dust pollution, and reduce the frequency of occurrence of defects.

The scrap metal crusher equipment has small discharge size and can adjust the fineness of the discharge freely. Any material with a large water content can be shredded, so that the shredding function of the equipment can be maximized.

When the waste metal shredder equipment is in operation, the bearing will produce heat, which directly affects the normal operation of the equipment and the production power. Our company reminds the majority of users that during the operation of the scrap metal crusher equipment, the bearing temperature rise and the noise of the bearing parts should be dealt with in a timely manner. What causes the bearing heating phenomenon to appear?

1. The oil pipe leaks oil and the oil supply pressure is lacking;

Second, the tubing is blocked and the lubricating grease activity is not smooth;

Third, the lubricating oil is too dirty, mixed with debris;

4. The open space between the bearing bush and the shaft is too small;

5. The selection of lubricating oil is not suitable, and the particle size is too large or too small;

6. There is no oil heater before the start of winter, the oil is too sticky;

7. In the summer, the lubricating oil from the oil pump does not pass through the oil cooler, or the oil cooler has disadvantages, such as water pipe blockage, poor water flow, and water cut;

Eight, the bearing circulating cooling water device has shortcomings, such as blockage;

9. The discharge opening is too small (the thrust plate is too long) to make the eccentric shaft too strong;

Ten, the drive belt is pulled too tight, the bearing is too strong.

The above is the reason why the metal shredder bearing heat is summarized in Yuxi. Through the above introduction, when there is a problem in your equipment, you can compare the above reasons, find the corresponding solution, and carry out maintenance.