How to deal with the clogging of the shredder?

Reasons for blockage of plastic shredder materials:
1.In the production of the shredder, the discharge speed will be too slow, the motor load will increase significantly, and the current meter pointer will oscillate and deviate. It can be judged that the shredder is blocked due to the too fast feed rate. If this happens, the speed adjustment of the feeding mechanism should be carried out immediately, and the feeding speed of the conveyor belt should be slowed down. After the standby machine resumes normal operation, the fixed feeding can be started. During the period, it is necessary to pay attention to the current meter pointer to control the current of 85% of the current. .
2.If the shredder discharge pipe is not smooth or the feed is too fast, the air outlet will be blocked; improper matching with the conveying equipment will cause the discharge pipe to weaken or block after the wind. If this is the case, clear the delivery equipment that does not match the delivery port, and adjust the feed amount to make the equipment operate normally.
3.The severe aging phenomenon of the shredder's hammer head wear is obvious. The hole diameter of the screen mesh hole will cause the output of the plastic shredder to decrease when the output of the plastic shredder is not working, which may cause the equipment to be blocked. In this case, the hammer should be screened in time. The net is cleaned by the aperture to keep the plastic shredder in good working condition.